![]() |
 
|
 |
![]()
![]() |
![]()
VENECIA
SOFTWARE PACKAGE FOR THERMAL HYDRAULIC ANALYSIS
OF
FORCED FLOW COOLED SUPERCONDUCTING EQUIPMENT
AND THEIR PRIMARY CRYOGENIC SUBSYSTEMS
DEMO VERSION
VENECIA DEMO is a free of charge software. The VENECIA DEMO contains trial
examples to demonstrate principal features and benefits of the code. The trial
examples are composed so as to demonstrate key capabilities and benefits of
VENECIA simulation.
User can change an input data of the examples to evaluate an adequacy of code.
The results of trial examples are illustrative and do not claim to be precise. In
particular, the mesh used in DEMO1 is rather rough for satisfactory
approximation of transition zones where He II transforms to He I and saturated
liquid He I transforms to saturated vapour. To achieve good approximation of
properties near the normal zone boundary and improve integral convergence the
mesh size should be fined by approximately 10 times (up to 0.01 m).
VENECIA DEMO does not allow the user any changes of the design of cryogenic
system in the trial examples. Other restrictions of the VENECIA DEMO are
mentioned in the chapters describing different VENECIA DEMO modules.
The trial examples for VENECIA DEMO were choosen from fusion researches as
the most complicated research area in comparing with other VENECIA’s
applications.
You may download:
Venecia DEMO. The Venecia DEMO software package (240 Mb), including 6 test tasks with parameters variable by user.
DEMO 1. The description of the Test Case #1 (NbTi superconductor cooled with superfluid helium).
DEMO 2. The description of the Test Case #2 (Supercritical helium loop).
DEMO 3. The description of the Test Cases for forced flow cooled cryopumps:
- Test case #3a - Rapid exhaust of 4K helium from one CP back to a cryoplant (recovery);
- Test case #3b - Rapid warm up of one CP from 4K to 100K. Test case #3b can be launched only after the Test case #3a.
- Test case #3c - Rapid cool-down of one CP from 100K down to 4K. Test case #3c can be launched only after the Test case #3b.
DEMO 4. The description of the Test Case #4: Cable in Conduit Conductor (CICC) quench modelling.
ReadMe. The manual for the Venecia DEMO software package.
Description. The description of the FULL Version of the VENECIA package.
Versions (Specifications). The comparative table of three VENECIA versions: VENECIA DEMO, VENECIA LIGHT, VENECIA FULL
|
|
 |
![]()
 ![]() |
![]()
Germany (headquarters): Alphysica GmbH. Unterreut, 6, D-76135, Karlsruhe, Germany,
Phone: +49 (0)163 904-85-61,
Fax: +49 (0)7219 444-26-55, E-mail: info@alphysica.com
![]()
USA: Alphysica Inc., Harvard Square, One Miffin Place, Cambridge, MA 02138, USA,
Phone/Fax: +1 (617) 715-1978, E-mail:usa@alphysica.com
![]()
China: Alphysica Ltd. 1 Jianguomenwai Avenue
Beijing, 100004, China,
Phone/Fax: +86 10 5737 2626 E-mail:china@alphysica.com
![]()
Russia: Alphysica Ltd. 55, Nevsky pr., 191025, St.Petersburg, Russia,
Phone/Fax: +7 (812) 335-95-04, E-mail: russia@alphysica.com
Copyright © 1994-2011
![]()
| |
|
![]() |
